为了提高高压静电分选效率,探究转辊表面电流分布规律.采用自制的线-辊式高压放电装置,改变电极排布,测量转辊表面电流分布.结果表明:在同等条件下,单根电晕线直径越小放电电流越大,转辊表面电流整体呈正态分布;2根电晕线放电时,电流分布范围扩大,整体电流增强;3根电晕线放电,在两外侧电晕线夹角为60°,3根电晕线与转辊表面间距均为45 mm的位置时,两外侧峰值电流在转辊表面上的夹角约为72°,总体电流较大且分布均匀,有利于待分选物料荷电,提高分选效率.本研究为优化静电分选装置电极设计提供依据.
In order to improve the efficiency of high-voltage electrostatic separation,the characteristics of discharge current on the roller surface were explored.The experimental device of high-voltage discharge was made.The influence of different location wires on discharge current on roller surface was studied.The results indicated that:under the same conditions,with the decrease of corona wire diameter,the discharge current became bigger.The current on the surface of roller was close to a normal state.When two corona lines were used to discharge,the spatial distribution of the current had larger range and higher intensity.When three corona lines were used to discharge,at one position,the current distribution measured was wider and relatively stable where the angle between two outer corona lines and the distance between the corona line and the surface of the roller were 60° and 45 mm respectively.In this case,the angle between two outboard peaks was about 72°.It is advantageous for the electric charge of the material to be sorted,as the efficiency of sorting is improved.The simulation provides a theoretical foundation for electrostatic separator design.
[1] LI J,WU G Q,XU Z M.Tribo-charging properties of waste plastic granules in process of tribo-electrostatic separation[J].Waste management,2015,35(2):36-41.
[2] LI H P,CHEN G X,WANG Z B,et al.Characteristics of the large area surface dielectric barrier discharge with a multi-electrode configuration[J].Power system technology,2013,39(9):2125-2130.
[3] TOUHAMI S,MEDLES K,DAHOU O,et al.Modeling and optimization of a roll-type electrostatic separation process using artificial neural networks[J].IEEE transactions on industry applications,2013,49(4):1773-1780.DOI:10.1109/TIA.2013.2256451.
[4] DUMITRAN L M,DASCALESCU L,ATTEN P,et al.Computational and experimental study of ionic space charge generated by combined corona electrostatic electrode systems[J].IEEE transactions on industry applications,2006,42(2):378-384.DOI:10.1109/IAS.2004.1348681.
[5] AMAN F,MORAR R,KOHNLECHNER R,et al.High-voltage electrode position:a key factor of electrostatic separation efficiency[J].IEEE Transactions on Industry Applications,2004,40(3):905-910.DOI:10.1109/TIA.2004.827813.
[6] ALAGOZ B B,ALISOY H Z,ALAGOZ S,et al.A space charge motion simulation with FDTD method and application in negative corona electrostatic field analysis[J].Applied Mathematics and Computation,2012,218(3):9007-9017.
[7] LI J,LU H Z,XU Z M,et al.A model for computing the trajectories of the conducting particles from waste printed circuit boards in corona electrostatic separators[J].Journal of Hazardous Materials,2008,151(1):52-57.
[8] 周全,李佳,许振明.基于LabVIEW的破碎废旧电路板处理设备过程监测系统的开发[J].微电脑应用,2010,26(6):36-38.DOI:10.3969/J.ISSN.1007-757X.2010.06.012. ZHOU Q,LI J,XU Z M.The development of process monitoring system of crushing waste circuit board processing equipment based on the LabVIEW[J].Microcomputer Application,2010,26(6):36-38.DOI:10.3969/J.ISSN.1007-757X.2010.06.012.
[9] 张子生,崔进,高娇娇,等.针辊式高压静电分选机电晕极结构优化[J].北京理工大学学报,2015,35(10):1006-1010.DOI:10.15918/j.tbit1001-0645.2015.10.004. ZHANG Z S,CUI J,GAO J J,et al.Structure optimization of corona electrode on the needle-roller high-voltage electrostatic separator[J].Transactions of Beijing Institute of Technology,2015,35(10):1006-1010.DOI:10.15918/j.tbit1001-0645.2015.10.004.
[10] 张子生,王艺,谢畅,等.针-弧面式高压放电电流特性实验研究[J].高电压技术,2014,40(7):2173-2178.DOI:10.13336/j.1003-6520.hve.2014.07.036. ZHANG Z S,WANG Y,XIE C,et al.Experimental study on current characteristics of needle-cambered high voltage discharge[J].High Voltage Engineering,2014,40(7):2173-2178.DOI:10.13336/j.1003-6520.hve.2014.07.036.
[11] 闫正,刘涛涛,张文明,等.高效脉冲放电协同 TiO2 处理染料废水[J].河北大学学报(自然科学版),2014,34(3):253-256.DOI:10.3969/j.issn.1000-1565.2014.03.007. YAN Z,LIU T T,ZHANG W M,et al.Treatment of dye wastewater by efficient pulse discharge plasma with TiO2[J].Journal of Hebei University(Natural Science Edition),2014,34(3):253-256.DOI:10.3969/j.issn.1000-1565.2014.03.007.
[12] 李庆,王利,杨青,等.板-袋收尘极板对微细粉尘收集效果的影响分析[J].高电压技术,2016,42(2):1-6.DOI:10.13336/j.1003-6520.hve.2016.02.000. LI Q,WANG L,YANG Q,et al.Analysis on the influence of board-bag collecting plate on the effect of the fine dust collection[J].High Voltage Engineering,2016,42(2):1-6.DOI:10.13336/j.1003-6520.hve.2016.02.000.
[13] 张子生,王艺,崔晋,等.针辊式高压静电分选电场的数值模拟[J].高电压技术,2015,41(2):485-490.DOI:10.13336/j.1003-6520.hve.2015.02.019. ZHANG Z S,WANG Y,CUI J,et al.Numerical simulation of electric field for needle-roller high voltage electrostatic separation[J].High Voltage Engineering,2015,41(2):485-490.DOI:10.13336/j.1003-6520.hve.2015.02.019.
