When a car runs at a high speed more than 100 km/h, the aerodynamic noise produced by the interaction of air flow and car body plays a leading role in the noise contribution of the vehicle, so it is very important to control the aerodynamic noise source outside the vehicle. The correlation between aerodynamic of the SUV rear mirror arm length and the interior noise environment of the vehicle was studied by the experimental method. The results show that the relationship between the parameters of the rear mirror arm length and sound energy is logarithmic. The relationship between the parameters of the rear mirror arm length and articulation is logarithmic, too. The relationship between the parameters of the rear mirror arm length and loudness follows quadratic equation. When the rear mirror arm length is controlled to be between 40~50 mm, the sound pressure level is reduced by 0.6 dB(A), the relative improvement is about 0.5%, the articulation is increased by 5.4% AI, the relative change is 9%~14%, the loudness is reduced by 0.5~0.6 sone, and the relative improvement is about 1.7%~2.1%. The technical method of the controlling aerodynamic noise in the rear mirror arm length has been obtained preliminarily. The technology reduces the noise in the car and improves the sound quality of the SUV.
LIU Haijun
,
GUO Hang
,
PENG Xingzhi
,
WU Yang
. Experimental on aerodynamic noise of side-mirror arm of a SUV[J]. Journal of Hebei University(Natural Science Edition), 2022
, 42(1)
: 85
-90
.
DOI: 10.3969/j.issn.1000-1565.2022.01.012
[1] LIGHTHILL M J. On sound generated aerodynamically I. General theory[J]. Mathematical and Physical Sciences, 1952, 211(1107): 564-587. DOI: 10.1098/rspa.1952.0060.
[2] LIGHTHILL M J. On sound generated aerodynamically I. Turbulence as a source of sound[J]. Mathematical and Physical Sciences, 1954, 222(1148): 1-32. DOI: 10.1098/rspa.1954.0049.
[3] MARIE CABOOL, YVES DETENT. A comparison between defects of Turbulent and Acoustic wall pressure actuations inside a car[Z]. 18th AIAA Aeroacoustics conference, Colorado Springs, 2012.
[4] GUIDATI S, SOTTEK R. Advanced source localization techniques using microphone arrays[J]. SAE Int J Passeng Cars-Mech Syst, 2011, 4(2): 1241-1249. DOI:10.4271/2011-01-1657.
[5] LEPLEY D, SENTHOORAN S, HENDRIANA D, et al. Numerical simulations and measurements of mirror-induced wind noise[J]. SAE Int J Passeng Cars-Mech Syst, 2009, 2(1): 1550-1562. DOI:10.4271/2009-01-2236.
[6] ADAM J, RICOT D, LAMBOURG C, et al. Correlated Beamforming Method for Relevant Aeroacoustic Sources Identification[Z].SAE 2009 Noise and Vibration Conference andExhibition,St Charles,Illinois,2009.
[7] LI L Z, LI J, LU B W,et al. Application of Beamforming to Side Mirror Aeroacoustic Noise Optimization[Z].SAE 2016 World Congress and Exhibition, Detroit, 2016.
[8] TOMAC M N, YUGULIS K, GREGORY J W, et al. Investigation of vibration phenomena induced by air flow over side view mirror[J]. J Fluids Eng, 2011, 133(12): 121102. DOI:10.1115/1.4005425.
[9] RICHARD WALKER, WEI WEI. Optimization of mirror angle for front window buffeting and wind noise using experimental menthods[Z]. Noise and Vibration Conference and Exhibition, Charles, Illinois, 2007.
[10] HARTMANN M, OCKER J, LEMKE T, et al. Wind Noise Caused by the A-pillar and the Side Mirror Flow of a Generic Vehicle Mode[Z].18th AIAA/CEAS Aeroacoustic Conference,Colorado Springs, 2012.
[11] TERAKADO S, MAKIHARA T, SUGIYAMA T, et al. Experimental investigation of aeroacoustic cabin noise in unsteady flow by means of a new turbulence generating device[J]. SAE Int J Passeng Cars Mech Syst, 2017, 10(1): 309-317. DOI:10.4271/2017-01-1545.
[12] 李启良,杨志刚,陈枫. 汽车后视镜流场的试验与数值研究[J].同济大学学报(自然科学版), 2011, 39(7): 1045-1049. DOI:10.3969/j.issn.0253-374x.2011.07.019.
[13] 王毅刚,杨超,杨志刚,等.汽车外表面气动噪声特性分析[J].声学技术, 2014, 33(1): 50-55. DOI:10.3969/j.issn1000-3630.2014.01.011.
[14] 陈鑫,冯晓,沈传亮,等.车外后视镜造型对气动噪声影响的实验研究[J].汽车工程, 2017, 39(2): 206-213. DOI:10.19562/j.chinasae.qcgc.2017.02.014.
[15] 贺银芝,杨志刚,王毅刚.某轿车车内气动噪声特性的试验研究[J].汽车工程, 2016, 38(1): 72-77. DOI:10.19562/j.chinasae.qcgc.2016.01.012.
[16] 贺银芝,董国旭,张涛,等.汽车车内噪声与车外气动声源的相关性研究[J].汽车工程, 2017, 39(10): 1192-1197. DOI:10.19562/j.chinasae.qcgc.2017.10.015.
[17] 刘海军,任秉银,徐旭,等.某SUV型汽车后视镜气动噪声数值仿真[J].哈尔滨工业大学学报, 2016, 48: 35-39.
[18] 陈鑫,阮新建,汪硕,等.仿生非光滑车外后视镜罩气动减阻降噪机理研究[J].湖南大学学报(自然科学版), 2020, 47(4): 16-23. DOI:10.16339/j.cnki.hdxbzkb.2020.04.003.
[19] DUAN M H, LAI C G,WANG Y. Numerical analysis of aerodynamic noise in the external and internal fields of a SUV[J]. MachineTool & Hydraulics, 2020, 48(6): 78-84.
[20] 唐荣江,胡宾飞,张淼,等.基于A柱-后视镜车内气动噪声数值模拟与预测[J]. 汽车工程, 2020, 42(4): 522-530. DOI:10.19562/j.chinasae.qcgc.2020.04.015.
[21] 袁海东, 杨志刚,李启良.汽车前侧窗表面压力激励及其源分析[J].湖南大学学报(自然科学版), 2019, 46(8): 9-19. DOI:10.16339/j.cnki.hdxbzkb.2019.08.002.
[22] 王毅刚,黄晓胜,危巍,等. 涡声理论在汽车A柱气动噪声优化中的应用[J].噪声与振动控制, 2017, 37(2): 107-112. DOI:10.3969/j.issn.1006-1355.2017.02.022. (
